Ronan X96S MASS FLOW GAUGE Manuel d'utilisateur télécharger pdf (Page 46)

Mechanical Mounting

Review the Configuration Drawing which is

included in the Drawing Chapter of this manual.

Please reference the dimensional drawings located

in the Drawing Chapter of this manual when

installing the equipment.

Consider the following general guidelines when

mounting the sensor and detector:

Avoid internal vessel obstructions such as baffles,

agitators,

manways, heater/cooler tubes, etc. which could

interfere with the transmission through the vessel of

the radiation's "active beam."

The source and detector must be rigidly mounted so

they do not move with respect to each other. Such

movement will destroy the system's calibration

and/or its measurement.

Insulation must be used at the point of installation

IF:

- the temperature of the vessel at that spot exceeds

120

F (50

C), or - the voltage transmission through

the vessel could interfere with the signal

transmission from the source to the detector.

Drawings:

Configuration

Installation

Drawin

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 76 77

Pas de commentaire

Ronan X96S MASS FLOW GAUGE Manuel d'utilisateur Page 46