Ronan X96S MASS FLOW GAUGE Manuel d'utilisateur télécharger pdf (Page 47)

Electrical Installation of Interconnect Wiring

DO NOT APPLY POWER until wiring is carefully checked.

Wire the equipment according to the detailed interconnect

drawing which is included in the Drawing section supplied .

Follow local and national electrical codes for all interconnections.

Consider the following guidelines before making any electrical

connections:

Use continuous conduit runs and protect housing junction

boxes from dripping of condensed moisture off of conduit.

Plug unused conduit holes to prevent entry of dirt and moisture.

Run the interconnect cable in a separate conduit. Feed the

cable through the conduit starting at the detector end and

terminate at the microprocessor end.

DO NOT run AC power cable in the same conduit with any of

the low-level cables (signal, mV, mA, etc.)

Maintain transient-free AC power sources between 105-130

VAC for the microprocessor. DO NOT use a line that is

connected to a large motor, welding equipment, solenoids, etc.

WITH POWER OFF - - -

Connect cable pre-wired MS connector to detector. Verify plug is

seated. Turn locking ring until it clicks.

Immediately replace lid of detector housing to keep out water and

dirt.

Check connections at microprocessor chassis terminals. Verify

that all wires are fully inserted in terminal sockets and the screws

are firmly tightened.

POWER INPUT

Drawin

Drawings:

Interconnect

LOCAL CODE

NATIONAL CODE

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 76 77

Pas de commentaire

Ronan X96S MASS FLOW GAUGE Manuel d'utilisateur Page 47