Ronan XSD-1000 Manuel d'utilisateur télécharger pdf (Page 64)

Troubleshooting the Detector

NOTE: Make sure the wiring from the detector to the Scintillator Input Remote I/O

Module is correct. If you have just replaced (or added) a Scintillator Input Remote I/O

Module when the Detector Failure occurred, refer to the Remote I/O Module Addressing

section to ensure you have properly addressed the Remote I/O Module.

• Remove the cable from the detector. This is a military style twist-off connector

located at the top of the detector.

• Make sure the Remote I/O Modules are powered up; the red LED on the Scintillator

Remote I/O Modules needs to be On or Flashing.

• Check the voltage at pins A & J of the twist-off connector. If you have greater than

14VDC at these pins, the detector needs to be repaired or replaced. Otherwise,

replace or repair the detector cable.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 80 81

Pas de commentaire

Ronan XSD-1000 Manuel d'utilisateur Page 64