Ronan XSD-1000 Manuel d'utilisateur télécharger pdf (Page 63)

Relay Failure

This failure will probably become apparent during a System Verify (Manual or

Automatic). If a failure occurs with an Alarm Relay, go to the Administrative Options –

Configure – Configure Relay Output Assignments, and re-assign the failed relay to

another working relay. The Alarm Relays are located in the Monitor Panel and will

require repair/replacement of the printed circuit board inside the unit.

If the relay failure is a Verification Notification relay, Speed Notification relay, or a Gate

Control relay, these are located on the frame in the Remote I/O Enclosure. See the

section on Remote I/O Failure for help here.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 80 81

Pas de commentaire

Ronan XSD-1000 Manuel d'utilisateur Page 63