Ronan XSD-1000 Manuel d'utilisateur télécharger pdf (Page 13)

Detector Names/Status

NOTE: the number of detectors displayed here is defined in the Administration Menus

under Configure – Detectors. This should be done before enabling any detectors.

Enter the names of each detector for clarity (North, Top, etc.), and each detector’s status

(Enabled/Disabled). Each detector should have a unique name for identification

purposes. The names you select will appear over the green box displaying that detector’s

averaged counts during Background mode, and the raw counts for that detector during

Truck Present mode. The names will also appear in the Log File report if an alarm occurs

for that detector. To change the Detector Names, highlight the name in the box, and type

in the new name.

All operational detectors’ status should be ‘Enabled’. Use the ‘Disable’ function if a

detector fails in order to disable constantly triggering the I/O Failure Alarm, until the

detector problem is resolved.

To change a detector’s status (Enabled/Disabled), click on the box. A check mark means

Enabled, a blank box means Disabled.

The detector values next to each check-box under the ‘Detector Enabled’ column are the

names used to wire the detectors to the proper Remote I/O modules (1A, 2A, etc.).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 80 81

Pas de commentaire

Ronan XSD-1000 Manuel d'utilisateur Page 13