Ronan X96S LEVEL GAGE Manuel d'utilisateur télécharger pdf (Page 34)

Electrical Installation of Interconnect Wiring

DO NOT APPLY POWER until wiring is carefully

checked.

Wire the equipment according to the detailed

interconnect

drawing which is included in the Drawing Chapter of

this manual.

Follow local and national electrical codes for all

interconnections.

Consider the following guidelines before making any

electrical connections:

Use continuous conduit runs and protect housing junction

boxes from dripping of condensed moisture off of conduit.

Plug unused conduit holes to prevent entry of dirt and moisture.

Run the interconnect cable in a separate conduit. Feed the

cable through the conduit starting at the detector end and

terminate at the microprocessor end.

DO NOT run AC power cable in the same conduit with any of

the low-level cables (signal, mV, mA, etc.)

Maintain transient-free AC power sources between 105-130

VAC for the microprocessor. DO NOT use a line that is

connected to a large motor, welding equipment, solenoids, etc.

WITH POWER OFF - - -

Connect cable pre-wired MS connector to detector.

Immediately replace lid of detector housing to keep out

water and dirt.

Check connections at microprocessor chassis terminals.

Verify that all wires are fully inserted in terminal

sockets and the screws firmly tightened.

Drawings

Drawings:

Interconnect

LOCAL CODE

NATIONAL CODE

POWER INPUT

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

Pas de commentaire

Ronan X96S LEVEL GAGE Manuel d'utilisateur Page 34