Ronan X96S MOLD LEVEL GAGE Manuel d'utilisateur télécharger pdf (Page 39)

Calibration

Calibration correlates the X96S's output to your actual mold level. It instructs the microprocessor to read and store the detector

counts for a low and high level of process. Once the system is conditioned to recognize the low and high level, it will provide a

4-20 mA output over the entire range of interest.

Step 1 Start at the Status Display

From the Status Display Screen, Press the F3 Key to display the

Password Screen (or the Main Menus if the password is disabled).

F1 F2 F3 F4

Ronan Engineering

X96S Mold Level Gage

Enter Password:

******

All0 RST0 EXIT ENTER

F1 F2 F3 F4

Ronan Engineering

X96S Mold Level

Status Display

Level

4.7500

MLM Ch.1 4.7500 in

Head Temp 92.00 degF

Filt Counts 1489

Raw Counts 1502

Time 08/04/06 08:05

Diagnostics

Lo-C

Hi-C

Back

Step 2 Password Menu

With the left most character * highlighted (All digits are set at

000000 at this point), enter in the password ‘101010’.

Press the ↑ key 1 time to make the left most character equal to 1.

Press the → key 2 times to move to the third character.

Press the ↑ key 1 time to make the third character equal to 1.

Press the → key 2 times to move to the fifth character.

Press the ↑ key 1 time to make the fifth character equal to 1.

Press the F4 key (enter) to accept the password.

This will take you to the Main Menu.

Note: If the wrong password was entered, press the F1 (All0) to set

all the characters back to a value of 000000. You can begin to re-

enter the password from the beginning. Pressing the F2 (RST0) will

set the individual character that is highlighted back to the value 0.

Note: For security reasons, each character will always be displayed

as an asterisk

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 60 61

Commentaires sur ces manuels

Pas de commentaire

Ronan X96S MOLD LEVEL GAGE Manuel d'utilisateur Page 39

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Ronan X96S MOLD LEVEL GAGE